ANALYZER III - For fast Analysis of Linear Circuits (IBM & compatibles) CAT.# 000-N02-00

  ANALYZER III is an analogue Circuit Simulator ideally suited to analyzing the
  frequency response behaviour of linear circuits like Audio Amplifiers ,
  Filters , Cross-Over Networks , Aerial Matching Networks and TV IF Amplifiers

  SEAMLESS INTEGRATION
  ANALYZER III may be used stand-alone or may be seamlessly integrated into
  EASY-PC Professional forming a single Schematic Capture , Circuit Simulation
  and PCB Layout system .

  FREQUENCY RESPONSE
  ANALYZER III not only plots the Frequency Response of the Gain but also the
  Phase Response , the Group Delay and the way in which the Input and Output
  Impedances vary with frequency .

  IMPEDANCE MATCHING
  These impedances often vary surprinsingly across a circuit's frequency range
  and are usually responsible for those awkward problems that arise when a
  circuit works perfectly in a test fixture where the source impedance is low
  and the load impedance very high but fails when connected into the rest of
  your system where the matching impedances are less than ideal .

  CHOICE OF SIMULATORS
  ANALYZER III is available in tow versions . The normal version will run in
  just about any PC simulating circuits of up to 130 nodes in just 640 K of RAM

  ANALYZER III Professional has all the features of the base version but
  requires a 386 or later processor with at least 2MB of RAM . This version
  will accept circuits with up to 750 nodes (in 16 MB)